ARTEX Artylac crack liquid 002 8 ml

Artylac crack liquid is a liquid that allows to obtain artificially aged coatings. It is used to decorate nails. Craquelure looks like a cracked layer of paint, through the cracks of which the bottom layer of the coating is visible.

Working technology:
It is used strictly on the sticky layer of gel polish.
The thickness of the layer affects the time and size of the cracks.
It dries in the air, so the application is done evenly in one layer like ordinary nail polish, it is necessary to coat in accelerated mode.
Acceleration of the effect of cracks is possible with the help of polymerization in a Ccfl lamp - 1-2 minutes, in a UV lamp - 2-4 minutes, air, airbrush.
Scope: used for decoration under the gel finish.
 
Application procedure:
Perform a manicure, apply gel polish on the base. For an intense color, it is necessary to apply on a colored support. For a more contrasting effect, it is recommended to apply on a white support.
Polymerization according to recommendations.
Do not remove the dispersion. Apply a thin, even layer of Crack Liquid to the colored finish.
Ccfl lamp curing 1-2 min., UV 2-4 min. depending on the thickness of the layer.
File the free edge.
Then, cover with the gel finish.
Note:

As the liquid dries in the air, there are a few tips for use:
Close the lid firmly.
Before use, it is necessary to remove the brush from the bottle and wipe the neck with a cloth moistened in an antiseptic. After use, clean the base of the brush, the brush itself and the mouth of the bottle so that no Artylac crack liquid remains on it.
If necessary, clean the inside of the cap.
Be careful not to form dry areas of Artylac crack liquid.

Work technology:

Artylac Classic is applied on the entire nail plate in 2 uniform layers. Depending on the thickness of the layer, polymerization in a CCFL lamp takes 30 seconds. or 60 seconds UV 120 sec.

Method of use:

Perform a manicure, matt the nail plate with a soft buff. Degrease the nail plate with FRESHNER "Profi Liquid". Apply a Bond Primer primer as needed over the entire nail plate or the free edge of the nail. Apply the base making a small camber. Polymerization according to recommendations. Apply Artylac Classic evenly. Polymerization of the coating in a CCFL lamp for 30-60 seconds. UV 120 sec. Apply any top. Note: the gel polish necessarily requires a base and a top coat.